Mec 4046SE - Operating Procedures and Safety Features

Page 20 SE
AC
Slab Series - Operator’s Manual
November 2022Section 7 - Operating Instructions & Functions Test
Operating Instructions
Check the area above and around the machine for obstructions and
electrical power lines before operating the machine.
ART_3353
Emergency Stop
Push in the red Emergency Stop button to the o󰀨 position at the ground
controls or the platform controls to stop all machine functions.
If any function operates when either red Emergency Stop button is pushed in,
repair the Emergency Stop function before using the machine.
Emergency Lowering
If the control system fails while the platform is elevated, use the
emergency lowering procedure to safely lower the platform.
Do not climb down the scissor assembly or exit the platform.
Emergency
Lowering Handle
ART_5884
The Emergency Lowering System is used to lower the platform in case of
power failure.
Pull the Emergency Lowering Handle to lower the platform.
Outdoor/Indoor Switch
To select the Indoor/Outdoor Mode press and hold the Platform Down Button,
the Platform Up Button and the Menu Enter Button for a few seconds to switch
to Indoor or Outdoor.
• INDOOR
• Select to allow unrestricted height when not exposed to wind.
• OUTDOOR
• Select to limit the maximum height when exposed to wind.
ART_5863C
Platform Overload
Indicates too much weight on the platform.
Remove weight from the platform to restore function and continue.
ART_5863D