Mec 4046SE - Maintenance Inspection Report

Page 36 SE
AC
Slab Series - Operator’s Manual
November 2022Section 9 - Maintenance
Maintenance Inspection Report
SE & MICRO Series Scissors
Fleet Equipment Number Date
Inspector Name Inspector Co.
Model Number Address
Serial Number
Hour Meter Signature
Machine Owner & address
Maintain all service records in accordance with ANSI A92.24-2019
*If an inspection receives an “N”, remove from service. Once repaired, place an R in the box.
*Refer to the proper service manual for specic information, settings and torque specications.
Key Y = Yes, Acceptable N = No, Remove from Service R = Repaired 0 = Not Applicable
QUARTERLY - Inspect only those marked “Q” ANNUAL - Inspect all items
Q/A Y/N/O R Q/A Y/N/O R
DECALS: X X X WHEELS: X X X
Legible - undamaged/readable Q Tire damage Q
Capacity decal correct for model Q Lug nuts (Wheel mounting) torqued correctly Q
RAILS: X X X King Pins lubed A
Not damaged, all in place Q COMPONENT AREA: X X X
All rail fasteners secure Q Hydraulic - no leaks Q
Entry gate secure, closes properly Q Hydraulic tank, correct level Q
Manual box in good condition Q Hoses not damaged - Fittings tight Q
Operators Manual in manual box Q Valve manifold secure, no leaks Q
PLATFORM EXTENSION: X X X Power unit secure, no leaks Q
Rolls in and out freely Q Batteries properly lled and cables clean Q
Lock holds deck in place Q Emergency stop, cuts power/operation Q
Release pedal moves freely (lube) Q Battery switch cuts battery feed Q
ELEVATING ASSEMBLY: X X X Plastic cover secure (door end 2632-4555 only) A
Scissor Slide Blocks, lubed Q Hydraulic tank, oil clean A
Maintenance Stand, good Cond Q Replace Hydraulic Filter (if equipped) A
Beam structures: Straight, no cracks A Clean or replace tank breather lter A
Welds: secure, no cracks A OPERATIONAL INSPECTION: X X X
Retaining Rings A All functions, operate smooth and quiet Q
Cylinder Pins, secure A All functions, speeds correct. Q
ELECTRICAL: X X X Upper control box, operates correctly Q
GFCI operates correctly Q Emergency Down, operates correctly Q
Wire harnesses good cond, secure A Limit switches slows drive when elevated Q
Comm cable no damage, secure A Pothole switch test Q
BASE: X X X Steering pressure relief, set correctly Q
Fasteners tight Q Lift pressure relief, set correctly Q
Cover panels secure Q **Check Platform Overload Sensing operation Q
Welds A
**For machine equipped with Platform Overload Protection system only