Mec 4046SE - Frequent Inspection Checklist

Page 35 SE
AC
Slab Series - Operator’s Manual
November 2022Section 9 - Maintenance
Frequent Inspection Checklist
This checklist must be used at 3-month intervals or every 150 hours of
machine use, whichever occurs rst. Failure to do so could result in
death or serious injury.
Frequent Maintenance Inspections should be conducted by qualied service technicians only.
Photocopy this page for reuse. Keep inspections records up to date. Record and report all
discrepancies to your supervisor. See the Service & Parts Manual for specic instructions.
Model Number Serial Number Hour Meter Reading
Initial Description
Perform all checks listed on Pre-Start Inspection.
Grease the Steering Yokes
Inspect the condition of hydraulic uid in the reservoir. Oil should be a clear and amber in color.
Batteries
Electrical wiring
Tires and wheels
Emergency stop
Key switch
Horn (if equipped)
Drive brakes
Drive speed - stowed
Drive speed - raised
Drive speed - slow
Tank venting system
Latch Components
Test Down & Pothole limit switches
Test Up limit switches
Additional maintenance requirements for severe conditions
If the machine is used in very dusty, exceptionally hot or exceptionally cold conditions, replace the
Hydraulic Cap Breather Filter and Hydraulic Filter (under normal conditions replace every 6 months or
300 hours, whichever comes rst).
Date Inspected By