Page 41 85
-
J - Operator’s Manual - 95803
January 2024Section 8 - Maintenance
Frequent Inspection Checklist
NOTICECAUTION
CAUTIONWARNING
ART_6091
This checklist must be used at 3-month intervals or every 150 hours of
machine use, whichever occurs rst. Failure to do so could result in
death or serious injury.
Frequent Maintenance Inspections should be conducted by qualied service technicians only.
Photocopy this page for reuse. Keep inspections records up to date. Record and report all
discrepancies to your supervisor.
Model Number Serial Number Hour Meter Reading
Perform all checks listed on Pre-Start Inspection.
Replace engine oil and lter after the rst 100 hours of service.
See engine operator’s manual for other engine maintenance information.
Inspect the condition of hydraulic uid in the reservoir. Oil should be a clear amber color.
Check battery electrolyte level and connections.
Check wheel lug nuts for proper torque (see Specications).
Check if tires are leaning in or out.
Inspect all structure and pivot points for signs of wear and/or damage.
Check the pin joints and retaining rings for security.
Inspect the entire machine for signs of damage, broken welds, loose bolts, improper or makeshift repairs.
Check that the platform does not drift down with a full load.
Check all wire connections for tightness and corrosion.
Check the operation speeds to ensure they are within specied limits (see Specications).
Check the Auxiliary Power System.
Clean and lubricate all push button switches with dry lubricant and ensure that the switches operate freely
in all positions.
Check the tightness of the platform frame and the linkage pins.
Check the overall platform and guardrail component security.
Check the electrical mounting and hardware connections for security.
Check the steering kingpins for excessive play.
Additional maintenance requirements for severe conditions
If the machine is used in very dusty, exceptionally hot or exceptionally cold conditions, replace hydraulic
lter element and air lter element (under normal conditions replace every 6 months or 300 hours,
whichever comes rst).
Date Inspected By
To Next Page
Loading...
