Mec 85-J - Serial Plate Information

Page 44 85
-
J - Operator’s Manual - 95803
January 2024Section 9 - Troubleshooting
Troubleshooting
NOTICECAUTION
CAUTIONWARNING
ART_6091
Should you experience erratic operation or notice any malfunction while
operating this machine, discontinue use immediately.
Call for assistance and report the incident to your supervisor, and do
not use the machine until it has been checked by a trained, qualied
mechanic.
Machine functions will not operate
• Adequate fuel supply?
• Proper fuel blend (i.e. winter blend in cold weather)?
• Battery properly connected?
• Battery fully charged?
• Circuit Breaker tripped?
• Function toggle switch or the Enable Switch not activated?
• Selector Key Switch in proper position?
• Both Emergency Stop Switches reset?
• Hydraulic uid level low?
• Obvious uid leak or damaged component?
• Wires disconnected, broken, or loose?
• LED should be ON.
• Contact MEC Technical Support.
• Technical Support
• Error code at Onboard Diagnostic Center?
• Contact MEC Customer Service.
Troubleshooting