Mecmesin MultiTest-x manual
10
operation can then be restored after the system has been re-set by twisting the
[Emergency Stop] button about 60º clockwise.
Software
Commands
There are four basic types of software instructions which can be entered via the
control panel:
i. A direct command
ii. Choosing a menu option
iii. Selecting an option from within a menu
iv. Typing in a value
i) Direct Command
A direct command is one to which the MultiTest-x system will attempt to respond
without delay. The direct commands are:
• Pressing [Jog Up] to move the crosshead up
• Pressing [Jog Dn] to move the crosshead down
• Pressing [Start/ENT] to run the current test procedure
• Pressing [Tare] to re-display the ‘tare screen’
Direct commands can only be executed from the ‘live test’ screen (see [1], <1>
Procedure Menu).
ii) Menu Options
The system communicates with the operator by means of an LCD display consisting
of four lines with twenty characters per line.
To Next Page
