Mecmesin MultiTest-x manual
6
Safe Operation of MultiTest-x Systems
Appendix 2 (page 37) gives guidance notes on the safe use of mains-powered test
frames; you should read this before proceeding any further. Within the European
Union (EU), a copy of this Appendix will, if appropriate, be supplied in a language
appropriate to your country by your local Mecmesin Agent.
Note: Although movement of the test stand crosshead can be stopped via software, in
an emergency pushing the [Emergency Stop] button on the left-hand side of the
control panel is the best method!
System Set-up and Operation
Connecting up
Connect the mains power lead to the three-pin power inlet connector at the rear of the
test stand (1),
To Next Page
Loading...
