Mecmesin MultiTest-x Series - 3] Control Menu

Mecmesin MultiTest-x manual
26
Once the limits of the first calculation have been specified, pressing [Start/ENT] will
display the screen associated with specifying the limits of the second calculation…
…and once the limits of the final calculation have been specified, pressing
[Start/ENT] will display the Analysis menu (see [1], [3], [2] ).
[1], [3], [2], <3> Auto XMit Res-OFF
Pressing [3] will toggle between options available (OFF or ON)
If the ‘ON’ option has been selected, when a test has been completed results will
automatically be downloaded to a PC or datalogger via the RS232 port on the rear
control panel. The option will remain after each individual test to decide whether
results should be downloaded (see [1], [2], [1] Send Test Results).
[1], [3], [2], [4] Calculate Results
a) this is the message that will be displayed if
either no calculations are associated with the current procedure, or if no data
exist from which to calculate results
b) will appear on the bottom line while results are
being re-calculated
Note that if data from some cycles are being discarded while a test is running (see [1],
[3], [3], [1], (j), Set Cyclic Logging) and if any result being reported uses an
‘occurrence’ parameter (see [1], [3], [2], <1> Select Analysis) there is a chance that an
unexpected result could be reported – unless, when specifying the occurrence
parameter, due account is taken of the fact that results will be based only upon data
for those cycles which have been recorded.
[1], [3], [3] Control Menu