Mecmesin MultiTest-x manual
5
Introduction
Thank you for choosing this Mecmesin console-controlled MultiTest-x test system,
which with correct use will give many years of reliable service.
The stand-alone MultiTest-x has been designed particularly for use in production
areas, which often prove to be unsuitable environments for PC operation. This
flexible, powerful, yet easy-to use system will carry out precise test procedures ‘at the
push of a button’, then automatically display test results and pass/fail analyses.
However, upon receiving the unit, before attempting to install it and begin testing,
please:
• Check that no obvious physical damage has been sustained by the
packaging material or the test system itself. If any damage is evident,
please notify Mecmesin or an Authorised Agent immediately.
• Before attempting to unpack or move the test system, refer to the safety
advice given in Appendix 2 (page 37).
• Appendix 1 (page 36) gives a list of items which should be included with
your system. If any item is missing, please notify Mecmesin or an
Authorised Agent immediately.
It is strongly recommend that all the packaging and fixings be retained for any future
transit requirements. When using the MultiTest-x system please ensure that the
ventilation holes situated on the back and bottom of the unit are not obstructed. Also
attach (hand tight only) the four rubber feet to the MultiTest-x system with the screws
provided.
Hardware
MultiTest 1-x, 2.5-x and 5-x are single-column test frames with a precision ballscrew
drive. MultiTest 10-i and MultiTest 25-i are twin-column test frames with dual precision
ballscrew drive.
To Next Page
Loading...
