Mecmesin MultiTest-x Series - Page 15

Mecmesin MultiTest-x manual
15
During a test the ‘status indicator’ can display:
• - crosshead travelling, but ‘Threshold’ not yet reached
• - crosshead travelling in response to ‘Touch’ command
• - crosshead travelling in response to Segment A command
• - crosshead travelling in response to above Segment B commands
• - crosshead is being driven back to ‘home’ position
• - test results being calculated (see below)
The test will stop when:
• The test procedure has been completed
• The [Stop/BK SP] key is pressed
• The [Emergency Stop] button is pressed, the ‘status indicator’
will be displayed
• A specimen break is detected, (see [1], [3], [1], [2])
• A ‘limit stop’ is reached. (If the lower limit is reached the ‘status indicator’ will
display the message , or, if the upper limit is reached
the ‘status indicator’ will display the message )