Mecmesin MultiTest-x Series - Page 77

Mecmesin MultiTest-x manual
77
load peaks. See Calculations, peak load
load troughs. See Calculations, minimum
load
loadcell deflection compensation. See
stiffness, system
loadholding, 27, 29, 51
logging rate, 20
M
main lead. See Connections, power lead
manual control. See jogging
maximum load. See Calculations, peak
load
mean load. See Calculations, average load
measurement units, 21
Menu
Acquisition, 19
Analysis, 21
Control, 26
Main, 13
Print, 16
Setup, 18
Utilities, 32
millimetre(mm). See measurement units
minute(m). See measurement units
modulus, elastic. See stiffness, sample
montonic test. See Procedure, monotonic
N
newton(N). See measurement units
O
occurrence, 22
on/off switch, 7
Operating environment
humidity, 38
temperature, 38
ounce-force(ozf). See measurement units
oveload, local, 20
P
parking crosshead, 30
pass/fail criteria. See tolerance limits,
setting
Password-protected facilities
calibration screen, 35
gain control, 31
re-installing defaults, 34
setting supervisor/operator access, 35
pound-force(lbf). See measurement units
Procedure
choosing, 14
cyclic, 27
defining, 27
dual segment, 27
monotonic, 27
naming, 33
running, 14
Programming. See Procedure, defining
R
Restrictions
access. See Password-protected
facilities
load. See oveload, local
travel. See limit stops
running to load, displacement time or
break. See Commands, END
S
safety considerations, 37, 40
sample break, defining, 19
Screen
calibration, 35
diagnostic, 34
LCD, 9
results, 16
testing, 14
second(s). See measurement units
spring rate. See stiffness, sample
status indicator, 15, 20, 30
stiffness, sample, 23
stiffness, system, 33
stopping test, 15
supervisor mode, 35
support for system. See system support
system support, 36