What to do if my mectron Dental equipment has insufficient performance?
If your equipment isn't performing well, check the following: * Make sure the insert is correctly tightened on the handpiece using the Mectron torque wrench. * Replace the insert if it is broken, worn-out, or deformed.
What to do if my mectron Dental equipment is on but not working?
If your device is on but not working, and the APC protection circuit has intervened, consider these possibilities: * Ensure the insert is correctly tightened using the Mectron torque wrench. * Replace the insert if it's broken, worn, or deformed. * Dry the handpiece or cord connector contacts thoroughly with compressed air. * Check that the handpiece is correctly connected to the cord.
General| LED Light | Yes |
|---|---|
| Control | Touch panel |
| Power Supply | 100-240 V, 50/60 Hz |
| Frequency | 24-36 kHz |
| Water Supply | Integrated |
| Application | Scaling, Endodontics, Periodontics |
| Tip Compatibility | Mectron tips |
| Type | Ultrasonic Piezoelectric Scaler |
To Next Page
