37
9.1.3.2 PointsofContactwiththePatient
an environment.
Phenomenon
BasicEMC
standardortest
method
Immunitytestlevels
Electromagnetic
environment-Guidance
Electrostatic
discharges
wood, concrete or ceramic
with synthetic material, the
relative humidity should be at
Conducted
disturbances
3 V
in ISM bands
communication devices
should not be used near any
part of the product, including
cables, except when they
respect the recommended
distances, calculated from the
The following apply:
•
individually or bundled
•
current clamp unless a current clamp is not suitable.
In cases were a current clamp is not suitable, an EM
clamp shall be used.
• No intentional decoupling device shall be used
between the injection point and the PATIENT
• Testing may be performed at other modulation
•
•
amateur radio band, as applicable, an additional test
band. This applies to each ISM and amateur radio
•
Discharges shall be applied with no connection to
simulation. PATIENT simulation may be connected
after the test as needed in order to verify BASIC
To Next Page
Loading...
