COMPACT PIEZO LED
9.1.3.3 PartsAccessibletotheInput/OutputSignals
an environment.
Phenomenon
BasicEMC
standardortest
method
Immunitytestlevels
Electromagnetic
environment-Guidance
Electrostatic
discharges
wood, concrete or ceramic
with synthetic material, the
relative humidity should be at
Electrical fast
bursts
supply should be that of a
typical commercial or hospital
environment.
supply should be that of a
typical commercial or hospital
environment.
Conducted
disturbances
3 V
in ISM bands
communication devices
should not be used near any
part of the product, including
cables, except when they
respect the recommended
distances, calculated from the
This test applies only to output lines intended to
connect directly to outdoor cables.
m in length are excluded.
Testing may be performed at other modulation
Calibration for current injection clamps shall be
perform air discharge testing to the connector shell
generator, with the exception that the only connector
pins that are tested are those that can be contacted or
touched, under conditions of INTENDED USE, by the
standard, applied in a bent or straight position.
Capacitive coupling shall be used.
amateur radio band, as applicable, an additional test
band. This applies to each ISM and amateur radio
To Next Page
Loading...
