41
Problem PossibleCause Solution
The insert tip is of the type
which does not provide the
Use an insert tip of the type
The water function is not
active.
Activate the water function.
The insert tip is clogged.
Unscrew the insert tip from
the handpiece and unclog
the insert tip water passage
by blowing compressed air
through it. If the problem
persists, replace the insert tip
with a new one.
The handpiece is clogged.
Mectron Service Center
Poor performance
The insert tip is not correctly
tightened on the handpiece
Unscrew and correctly screw
(see
Chapter 4.4 on page
12
deformed
new one.
Insert tip not properly
maintained
Properly clean and maintain
the insert tip (see
on page 17
Table6 –
To Next Page
Loading...
