mectron Piezosurgery II - 00.3 - Intended Use; 00.4 - Safety Requirements

6
Piezosurgery // - manual of use and maintenance
7
Piezosurgery // - manual of use and maintenance
01.0 Identication data
01.1 Identication data
An exact description of the model including the serial number of the equipment will make it easier
for our After-Sale Service to respond quickly and efciently to your queries.
Always provide the above information whenever you contact a Mectron Service Centre.
01.2 Data plate of the device
Each device has its own data plate (Fig.1), on which its technical specications and serial number
are indicated. The data plate is on the rear of the device. The remaining data are included in this
manual (see Section “13.0”).
01.3 Data plate of the scaler handpiece
The serial number of this Piezosurgery handpiece is engraved on the ringnut (Fig.2 - Ref.A).
02.0 Testing
02.1 Testing of the equipment
All equipment manufactured by MECTRON is thoroughly checked and tested, including all compo-
nents.
During the testing procedure the components are subjected to a number of work cycles.
The tests highlight any malfunctioning due to faulty components.
This procedure ensures proper functioning and reliability of all components.
03.0 Delivery
03.1 Delivery of the apparatus
The equipment contains electronic components that may be damaged by impacts even inside the
packaging. Special care must therefore be taken for both transport and storage.
In order to avoid crushing, do not place cartons on top of one.
All material shipped by MECTRON is checked at the time of shipment.
The equipment is delivered properly protected and packaged.
At the time of receipt of the equipment check it for possible transport damage. If any damage is
found, make a complaint to the carrier.
Fig. 2
A
Fig. 1