35
7.1.2 AccessiblePartsoftheCasing
below.
environment.
Phenomenon
BasicEMC
standardortest
method
Immunitytestlevels
Electromagnetic
EnvironmentGuidance
Electrostatic
discharge
wood, concrete or ceramic
with synthetic material, the
relative humidity should be at
least equal to 30 %.
Radiated RF
Portable and mobile RF
communication devices
should not be used near any
part of the product, including
respect the recommended
distances, calculated from the
equation applicable at the
frequency of the transmitter.
frequency
magnetic
mains frequency should
have levels characteristic
of a typical location in a
commercial or hospital
environment.
physiological signal simulation, if used, and the
PIEZOSURGERY® plus shall be located within 0,1 m
orientation of the PIEZOSURGERY® plus.
PIEZOSURGERY® plus that intentionally receives
RF electromagnetic energy for the purpose of
its operation shall be tested at the frequency of
intentional receiver when an ambient signal is in the
passband. It is understood that the receiver might not
achieve normal reception during the test.
with magnetically sensitive components or circuitry.
During the test, the PIEZOSURGERY® plus may be
same frequency as the test signal.
Before modulation is applied.
the PIEZOSURGERY® plus and sources of power
used closer than 15 cm to sources of power frequency
distance.
To Next Page
Loading...
