7.1.3.3 PartsAccessibletotheInput/OutputSignals
below.
environment.
Phenomenon
BasicEMC
standardortest
method
Immunitytestlevels
Electromagnetic
EnvironmentGuidance
Electrostatic
discharges
wood, concrete or ceramic
with synthetic material, the
relative humidity should be at
least equal to 30%.
Electrical fast
bursts
frequency
voltage should be that of a
typical commercial or hospital
environment.
voltage should be that of a
typical commercial or hospital
environment.
disturbances
induced by RF
3 V
6 V
in the ISM bands
Portable and mobile RF
communication devices
should not be used near any
part of the product, including
respect the recommended
distances, calculated from the
equation applicable at the
frequency of the transmitter.
connect directly to outdoor cables.
perform air discharge testing to the connector shell
pins that are tested are those that can be contacted or
standard, applied in a bent or straight position.
amateur radio band, as applicable, an additional test
frequency shall be used in the ISM or amateur radio
R.M.S., before modulation os applied.
To Next Page
Loading...
