Chapter 4 Operation
- 12 -
Under the Operator List Interface, press the Function key and switch through the list to select the
operator. If an operator is selected, press the Scan button to save automatically and “*” is
displayed on the left of the selected operator.
4.2.2.2 Test Mode
Test Mode is used for the measurement on a bladder scanner phantom. Press and hold the Menu
key under the System Setting interface until you switch to the Test Mode interface, as shown in Fig.
4.4.
Fig. 4.4 Test Mode Interface
Press the Function key to turn the Test Mode on or off, “ON” or “OFF” prompts on the screen.
“ON” indicates the Test Mode is on and “OFF” indicates the Test Mode is off. The Test Mode is
turned on only when the Main Unit is tested on the bladder scanner phantom; it should be turned
off when the Main Unit is used on patient.
Note: The Test Mode is only used for testing on bladder scanner phantom; it is not
applied to patients. Don’t turn it on at will.
4.2.2.3 Serial Number of the Main Unit
Press the Menu key continuously under the System Setting interface until you switch to the Main
Unit Serial Number interface, as shown in Fig. 4.5. The interface displays the name of the Main
Unit, Wi-Fi password and Wi-Fi ON-OFF state.
WIFI：
N:PRB0_0G10002
P:medascan
ON
Fig. 4.5 Interface of Main Unit Serial Number
Press the Function key to turn Wi-Fi on or off and “ON” or “OFF” prompts on the screen. “ON”
indicates the Wi-Fi connection is on and “OFF” indicates the Wi-Fi connection is off.
To Next Page
Loading...