Chapter 6. Maintenance and Trouble Shooting
- 43 -
5. Avoid charging near fire or in direct sunlight
Otherwise, it will cause the battery’s internal protection circuit and its function to be lost or be
subject to abnormal chemical reactions, the battery may be hot, smoking, deformed or burning.
6. Charging the device with a non-dedicated charger may be dangerous
Charging under abnormal condition will cause the battery’s internal protection circuit and its
function to be lost or subject to abnormal chemical reactions, the battery may be hot, smoking,
deformed or burning.
7. Forbid to damage the device
Do not knock and hammer the battery with metal, or damage the battery in any other ways.
Otherwise, it will cause the battery to be over-heated, smoking, deformed or burning, or even put it
in danger.
8. Forbid to charge the device directly on the power socket or car cigarette lighter
High voltage and high current will damage the battery and reduce its service life, or even cause the
battery to be over-heated, smoking, deformed or burning.
9. Do not touch the leaked battery.
10. Stop using the device if it leaks. The leaked electrolyte will cause the skin to be
uncomfortable. If it is dropped into eyes, do not rub the eyes, but wash them immediately,
and go to the hospital for further treatment.
6.2.3 Warnings
1. If the charging time is much more (more than 24 hours) than the normal charging time,
please stop charging. The abnormal charging will cause the battery to heat, smoke, deform
or burn.
2. Do not put the device into a microwave oven or any other pressure equipment. If it is instantly
heated or leaks (or odors), remove the charger and stop using it. The abnormal battery will
cause over-heating, smoking, deformation or burning.
3. The charger has obtained the medical electronic device safety qualification. If it is lost or
damaged, please contact the manufacturer to purchase a new one; use of charger other than
that is provided by the manufacturer may cause increased electromagnetic emissions or
decreased electromagnetic immunity of this device and result in abnormal operation and
undesirable impact on product safety. The manufacturer shall not be responsible for any
consequences arising therefrom.
4. Portable RF communications equipment (including peripherals such as antenna cables and
external antennas) should be used no closer than 30 cm (12 inches) to any part of MD-6000P.
Otherwise, degradation of the performance of the device could result.
5. Use of the device adjacent to or stacked with other equipment should be avoided because it
could result in improper operation. If such use is necessary, MD-6000P and the other
equipment should be observed to verify that they are operating normally.
To Next Page
Loading...