Chapter 4 Operation
- 23 -
prompt scanning and the bladder volume will be displayed.
6. Press the Menu key to view the projection image, and select the appropriate position and angle
of the Main Unit according to the projection position.
7. Usually, make 3 to 5 measurements for the same patient and select a more accurate
measurement result.
4.3 Operation Instructions for the Jointly-Used Tablet PC
4.3.1 Start-up and Shut-down of the Tablet PC
4.3.1.1 Check-up before Start-up
1. Environment
Check whether there is nearby equipment that may emit disturbing radiation.
Check whether a dry place is selected.
2. Appearance
Check whether there are cracks on the enclosure of the device and the OLED screen.
3. Above check-ups should be done before you start up the device.
4.3.1.2 Start-up
Press the power switch button until the LCD lights up.
4.3.1.3 Check-up before use
Please do the following routine check-ups after the device is started up and before use.
1. Whether the screen displays properly;
2. Whether the operations of screen are active;
3. Whether the Tablet PC gets enough battery power.
4.3.1.4 Shut-down of the Tablet PC
Press the power switch for 3 seconds and touch the shut-down item on the screen to shut the
device down.
4.3.2 Configuration of the Tablet PC and Software Installation Instructions
4.3.2.1 System Configuration
1. Operating system requirements: Android;
2. Memory requirements: not less than 1GB;
3. Storage requirements: not less than 16GB;
4. Processor frequency: not less than 1GHz;
To Next Page
Loading...