MediaTek Proprietary and Confidential. © 2022 MediaTek Inc. All rights reserved. Unauthorized reproduction or disclosure of this document, in whole or in part, is strictly prohibited.
Genio 1200 Evaluation Kit User Guide
6 Software
Genio 1200 EVK is supported by two different software stacks: Android and Yocto. The pre-installed software for
Genio 1200 EVK is Android
Another software stack, IoT Yocto, is also provided as a separate download. The following sections describe how to
build, get, and flash the images for Android and Yocto system respectively
6.1 Android
6.1.1 Android Software Project and Configuration
Table 6-1 Android Project Name and Configuration
Project Name Configuration
AIOT8395P6_64_BSP IoT EVK+MT7921
6.1.2 How to Get Android Software Image
Please contact with your VAR, Distributor, MediaTek FAE.
6.1.3 Android Software Image Flash Method
Following steps can reflash the system codes of Genio 1200 EVK board.
1. Connect ADB port to PC via USB Type-C connector (J12)
2. Execute MediaTek Flash Tool
3. Select the proper Android scatter txt file
4. Select the download mode (“Firmware Upgrade” is pref
erred.)
5. Start download by pressing the button of “Download”
6. Plug in the DC power cord, the downloader will start
Note: If the downloader does not start, please press Download button and plug in the DC power cord will execute a force
download.
To Next Page
