Chapter 1 - Using the Mediatrix 1104 User’s Manual (SIP Version)
Mediatrix 1104
11
Using the Call For-
ward Feature
There are three types of Call Forward:
Unconditional
On Busy
On No Answer
Call Forward
Unconditional
The Call Forward – Unconditional feature allows you to forward your
calls to another extension or line. When forwarding your calls outside
the system, a brief ring is heard on your phone to remind you that the
call forward service is active. You can still make calls from your phone.
This assumes that your system administrator has properly enabled the
Call Forward – Unconditional service.
X To forward calls:
1. Take the receiver off-hook.
2. Wait for the dial tone.
3. Dial the sequence your system administrator has
implemented to activate the call forward – unconditional
service.
This sequence could be something like *70.
4. Wait for the transfer tone (three “beeps”) followed by the dial
tone.
5. Dial the number to which you want to forward your calls.
Dial any access code if required.
6. Wait for three “beeps” followed by a silent pause.
The call forward is established.
7. Hang up your phone.
The calls are checked against the digit maps set up by your
system administrator. See your system administrator for
more information.
X To check if the call forward has been properly established:
1. Take the receiver off-hook.
2. Wait for the dial tone.
3. Dial your extension or phone number.
The call is forwarded to the desired phone number.
To Next Page
Loading...
