Appendix A - Standards Compliance User’s Manual (SIP Version)
Mediatrix 1104
18
Disclaimers The following are the disclaimers related to the Mediatrix 1104.
Federal Com-
munications
Commission
(FCC) Part 15
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help
Telecom • FCC Part 68:Subpart D
• Industry Canada (CS-03, Issue 8, Part
1)
• TBR 21: January 1998
• ACA TS002 - 1997
Table 1: Standards Compliance (Continued)
Category Specification
Note: The standards compliance of the Mediatrix 1104 are printed
on a sticker located on the bottom of the unit.
Note: Any changes or modifications not expressly approved by
Mediatrix Telecom, Inc. could void the user’s authority to operate the
equipment.
To Next Page
Loading...
