Mediatrix 1104 - Call Forward on No Answer

Chapter 1 - Using the Mediatrix 1104 User’s Manual (SIP Version)
Mediatrix 1104
13
X To cancel the call forward:
1. Take the receiver off-hook.
2. Wait for the dial tone.
3. Dial the sequence your system administrator has
implemented to deactivate the call forward on busy service.
This sequence could be something like *73.
4. Wait for the transfer tone (three “beeps”) followed by the dial
tone.
The call forward is cancelled.
5. Hang up your phone.
Call Forward
on No Answer
The Call Forward – On No Answer feature allows you to forward your
calls to a pre-determined extension if you do not answer before a
specific amount of time. This amount of time has been set up by your
system administrator.
This assumes that your system administrator has properly enabled the
Call Forward on No Answer service.
X To forward calls:
1. Take the receiver off-hook.
2. Wait for the dial tone.
3. Dial the sequence your system administrator has
implemented to activate the call forward on no answer
service.
This sequence could be something like *74.
4. Wait for the transfer tone (three “beeps”) followed by the dial
tone.
5. Dial the number to which you want to forward your calls.
Dial any access code if required.
6. Wait for three “beeps” followed by a silent pause.
The call forward is established.
7. Hang up your phone.
The calls are checked against the digit maps set up by your
system administrator. See your system administrator for
more information.