24
214 Primary Relay
Control Error
The Watchdog has detected the inappropriate activation of the Primary
Relay.
215 MP1 Relay Control
Error
The Watchdog Microcontroller has detected inappropriate activation of the
MP1 Relay.
216 MP2 Relay Control
Error
The Watchdog Microcontroller has detected inappropriate activation of the
MP2 Relay.
217 Secondary Relay
Control Error
The Watchdog Microcontroller detected a failure of the Secondary Relay.
218 Frequency Error The Watchdog Microcontroller has detected the incorrect output waveform.
219 Power Control Error The Watchdog Microcontroller has detected the incorrect power setting on
the HVPS.
220 Active Measurement
Diagnostics Error I+
An error was detected in the I+ current sense network during Power On
Self Test (POST).
221 Active Measurement
Diagnostics Error
VSV
An error was detected in the voltage sense network (VSV) during Power
On Self Test (POST).
222 Idle State Feedback
Error
The analog signal levels are above the specified levels during an idle state
condition.
223 WD_Primary Relay
Sense Error
The Watchdog Microcontroller detected an error in the Primary Relay.
224 WD MP1 Relay
Sense Error
The Watchdog Microcontroller detected an error in the MP1 Relay.
225 WD MP2 Relay
Sense Error
The Watchdog Microcontroller detected an error in the MP2 Relay.
226 WD Secondary
Relay Sense Error
The Watchdog Microcontroller detected an error in the Secondary Relay.
227 Master Primary
Relay Sense Error
The Master Microcontroller detected an error in the Primary Relay.
228 Master MP1 Relay
Sense Error
The Master Microcontroller detected an error in the Primary Relay.
229 Master MP2 Relay
Sense Error
The Master Microcontroller detected an error in the MP2 Relay.
230 Master Secondary
Relay Sense Error
The Master Microcontroller detected an error in the Secondary Relay.
To Next Page
Loading...