44
Appendix A – Sending, Storing, Deleting and Recalling Test Results
(MFT1835 only)
Table of Symbols
Symbol Definition
L – E Live to Earth Test
L – n Live to Neutral Test
n – E Neutral to Earth Test
L - L Live to Live Test
R1 Circuit Protective Conductor
R2 Live
R12 R1 + R2
RR1 Ring Circuit Phase-Phase
RR2 Ring Circuit CPC-CPC
rrn Ring Circuit Neutral-Neutral
--- No connection selected
Storing Test Results in the internal memory
Note that in order to store test data, the Store Mode needs to be set to Internal or Internal and Bluetooth. See section 10 SETUP
OPTIONS for further details.
1. Perform the desired test as described previously.
2. Press and release the Bluetooth (Lock) button to display the first option. This will be the Connection for some tests (Insulation,
Continuity, Loop L-L/L-N) or Job number for other tests.
3. Use the Right Lock / RIGHT TEST buttons to scroll through the values until the one you need is reached.
4. Press and release the Bluetooth (Lock) button again to display each of the remaining options (Job, Distribution Board, Circuit,
Phase) and use the Right Lock / RIGHT TEST buttons to change these values as required.
5. To complete the store, press and hold the Bluetooth (Lock) button until ‘Str Ok’ is displayed.
Notes
1. If a particular option does not need to be changed from the value set during the previous stored result, it does not need to be
displayed prior to storage.
2. The only available option for stored Earth test results is the Job number.
Deleting Test Results from the internal memory
1. Turn the RIGHT rotary range knob to the DEL range.
2. Use the Bluetooth (Lock) button to select either LSt (last stored result) or ALL (all stored results).
3. Press and hold the Bluetooth (Lock) button until ‘no’ is displayed.
4. Use the Right Lock / RIGHT TEST buttons to display ‘YES’.
5. Press and hold the Bluetooth (Lock) button until ‘dEL Ok’ is displayed.
To Next Page
Loading...
Need help?
General
