9712938 46 / 68
Design and construction subject to change without prior notice!
No. Display text Note / possible cause Measures / remedial action
117
Top wash system
blocked/missing
• Rotating arm system above
• Ensure top wash arm system
can move freely
• If applicable, insert wash arm
system
• If needed, remove dirt particles
and ferrous metal particles from
the magnet
118
Bottom wash arm
system
blocked/missing
• Rotating arm system below
127
Temperature in-
crease not reached
• Tank set temperature/temperature
increase is not reached
• Temperature probe defective
• Heating defective
• I/O circuit board is defective
• If the error message reoccurs,
call a service engineer
200
Boiler level during
filling not reached
early enough
• No or insufficient water inlet water
supply
• Open the local water supply
• Check pre-filter/sieve and
clean, if necessary
201
Level not reached
after end of maxi-
mum final rinse du-
ration
• Booster pump without function
• Level detection defective
• Final rinse system clogged
• Not possible to continue work-
ing
• Call a service technician!
203
Final rinse temper-
ature not reached
• Boiler set temperature is not
reached
• Temperature probe defective
• Heating defective
• Call a service technician!
204
Over-temperature
boiler
• Maximum boiler temperature ex-
ceeded, check parameters
• Contactor / relay on I/O circuit
board is sticking
• Temperature sensor defective
• Plug-contact for temperature sen-
sor
high resistance
• Switch off the building-side
fuses
• Call a service technician!
205
Maximum final
rinse cycles insuffi-
cient
• Insufficient rinse aid quantity for
functional level in the water tank.
• If needed, Water absorption by
washed items.
• Sort the items to be washed
correctly
• Possible to continue working
To Next Page
Loading...
Need help?
General
