Care and maintenance
56
ENGLISH
7
43
43
Fig. 18: Turn the inlet, 1
41
42
43
43
40
Fig. 19: Turn the inlet, 2
1. Pull the milk hose o the appliance.
2. Push the outlet (7) down as far as it will
go.
3. Press the locking mechanism(43) of
the milk unit(40) together using two
ngers and pull the milk unit down-
wards o the outlet.
4. Pull the milk distributor (41) upwards
out of the milk unit.
5. Turn the inlet (42) by 180°.
Installation is carried out as described in
reverse order.
Information
To install, push the milk unit(41) onto the
outlet (7) using both hands. Make sure
that the locking mechanism(43) audibly
engages on both sides.
9 Care and maintenance
Regular cleaning and maintenance ensure
the consistent high quality of your bever-
ages.
9.1 General cleaning
Clean the appliance regularly. Immediately
remove external soiling caused by milk
and coee.
ATTENTION
The use of unsuitable cleaning agents
can lead to scratched surfaces.
Do not use any abrasive cloths, sponges
or cleaning agents.
Requirement: The appliance is switched
o.
Clean the outside of the appliance with
a soft, damp cloth and normal wash-
ing-up liquid.
Rinse the drip tray and the coee
grounds container with a soft, damp
cloth and normal washing-up liquid.
Clean the bean container with a soft,
dry cloth.
9.2 Rinsing the coee system
During rinsing, the nozzles at the outlet
and the internal parts of the coee system
are rinsed. As a result, rinsing water from
the interior enters the drip tray.
If switch-o rinsing is not deactivated, the
appliance rinses the coee system when
switching on and o.
Rinsing can also be carried out manually.
Requirement: The ready symbol appears
on the display.
1. Place a vessel beneath the outlet.
2. Press the "menu/ok" button for 2sec-
onds.
» The menu appears on the display.
3. Navigate to the Care > Rinsing menu.
4. Use the arrow buttons to select Start
and conrm with "menu/ok".
» The coee system is rinsed.
» The ready symbol appears on the
display.
To Next Page
Loading...
Need help?
General
