Melitta Caffeo Barista T Smart - Using Ground Coffee; Water Tank Filling; Adjusting the Coffee Outlet Height

Basic operation
46
ENGLISH
4.6 Using ground coee
Ground coee may also be used to pre-
pare coee beverages.
ATTENTION
The use of unsuitable types of coee can
lead to clogging of the brewing unit.
 Do not use any instant products.
 Fill a maximum of one coee spoon of
ground coee into the ground coee
chute.
4
Fig. 10: Ground coee chute
1. Open the lid of the ground coee
chute(4).
2. Use the enclosed coee spoon for
dosing.
Fill a maximum of one coee spoon of
ground coee into the ground coee
chute.
3. Close the lid of the ground coee
chute.
4. Proceed as described in sections 5 to 7.
Information
ū Two-cup dispensing is not possible
when using ground coee.
ū If no coee is prepared within 3
minutes of opening the ground coee
chute, the appliance switches to opera-
tion with coee beans and the ground
coee is discharged into the coee
grounds container.
4.7 Filling with water
Only use fresh, cold water without carbon
dioxide for optimum coee enjoyment.
Change the water daily.
Information
The quality of the water largely determines
the avour of the coee. Therefore, use a
water lter (see section9.8, page60 and
section9.9, page60).
1
Fig. 11: Water tank
1. Open the lid of the water tank and pull
the water tank (1) upwards out of the
appliance by the handle.
2. Fill the water tank with water.
Note the maximum capacity of 1.8
litres.
3. Insert the water tank into the appliance
from above and close the lid.
4.8 Adjusting the outlet
The outlet (7) is height-adjustable. Set the
greatest possible distance between the
outlet and the vessel. Depending on the
vessel, push the outlet up or down.
7
Fig. 12: Height-adjustable outlet