FAST program
>Off< On
FAST - time 1
from 09:30 to 10:30
FAST - time 2
from 22:00 to 05:00
FAST - time 1
from --:-- to --:--
➁
➂
➀
➃
11.k FAST-Program
This function allows you to set up to 3 time periods in
which the machine should reach its maximum
performance. This is useful if there are set times
during which you require large amounts of coffee.
Activate / deactivate FAST program
➀ If the display shows "FAST program", you can
press the
+ /–buttons to switch between the
following options. Choose ...
– "Off" to deactivate the programme or
– "On" to activate it and set the relevant
values.
Setting FAST times
If the FAST program function is activated ("ON"), you
can set the desired FAST times. To do this ...
➁ press the
SET button, to display Start time and
End time. Both values must be set; otherwise,
the value 00:00 is automatically adopted.
❍ Choose the position that you would like to
change. This is indicated by an underscore
(cursor). Navigate with the ...
❍ CC button to the right and
❍ the
JW to the left.
❍ Press the
+ /–buttons to increase or
decrease the highlighted value.
➂ If the end time is before the start time, the FAST
program remains activated until the following day.
➃ If you change from "23:59" to "00:00", "--:--" is
displayed. If you set this as start and end time,
the FAST time is ineffective.
❍ By pressing the
SET button, the chosen setting is
stored and the next function setting displayed. If
you wish to set other FAST times, press the
SET
button, until the desired function setting is
displayed.
Note: The FAST times become ineffective, if
"Automatic storage draining" has been activated by
our Technical Service staff (see 12.a). In this case,
the FAST program cannot be activated and the "Off"
setting blinks on the display.
+ /–
CC
JW
SET JC
GB
18
a_F_ c2000_en.dtp
To Next Page
Loading...
