#> ethtool -i eth<n>
ConnectX®-2 VPI Single and Dual Port QSFP InfiniBand and Ethernet Adapter Card User Manual Rev 1.6
Mellanox Technologies
35
Example:
ethtool -i eth0
driver: igb
version: 2.1.0-k2
firmware-version: 1.4-3
bus-info: 0000:01:00.0
#> ethtool -i eth0
driver: bnx2
version: 2.0.2
firmware-version: 5.0.11 NCSI 2.0.4
bus-info: 0000:01:00.0
• The mlx4_en parameters can be found under /sys/module/mlx4_en (or /sys/module/mlx4_en/
parameters, depending on the OS) and can be listed using the command:
#> modinfo mlx4_en
To set non-default values to module parameters, the following line should be added to the file/etc/
modprobe.conf:
"options mlx4_en <param_name>=<va
lue> <param_name>=<value> ..."
Ethernet Network Tuning
To improve network performance by tuning your network
see the Mellanox Performance Tuning
Guide located at:
www.mellanox.com => Products => Softw
are/Drivers => Ethernet SW/Drivers => Linux Driver
4.1.2 Windows
For Windows, download and install the latest Mellanox WinOF VPI for Windows software pack-
age available via the Mellanox web site at: http://www
.mellanox.com => Products => Software/
Drivers => InfiniBand & VPI Software/Drivers => Mellanox WinOF VPI => Download. Follow
the installation instructions included in the download package (also available from the download
page). To ensure that communication has been established follow the instructions below.
To Next Page
Loading...
Need help?
General
