PERFECT page 15
9. Weekly programmer
PRINT
SETUP
In this operating mode the weekly programmer is activated and the oven switches on and off automatically
at the programmed times.
While the weekly programmer is in the OFF phase the oven is in standby mode. Heating and fan are
switched off, the controller display is dimmed and shows the clock time.
The sequence of the weekly programmer is repeated every week.
A maximum of 9 time blocks, each consisting of ON time and OFF time, can be programmed.
Clockwise rotation of the push/turn control is used to select the temperature setpoint (etc.) to which the
oven has to control during the ON phase. If no settings are made the controller takes the values from
operating mode I.
Mo
Tu
We
Th
Fr
Sa
Su
h
on
off
By clockwise rotation of the push/turn control the parameters can be selected as in operating mode I, and
altered as described in Section „Setting the parameters“.
The time blocks are selected by rotating the push/turn control anticlockwise. The switching times can be
altered while holding down the SET key.
Weekday
Range: Monday to Sunday
Mo
Tu
We
Th
Fr
Sa
Su
Day groups
Range: workday Mo-Fr
weekend Sa-Su
Mo
Tu
We
Th
Fr
Sa
Su
Mo
Tu
We
Th
Fr
Sa
Su
No ON time: ----
On these days the oven is not
switched on
on
off
ON time
Range: 00:00 to 23:59 hrs
on
off
h
OFF time
Range: one minute above ON time to
24:00
on
off
h
For safety reasons, always check that an ON time has been programmed only during the required time
blocks and days.
To Next Page
Loading...
