Table 2 – Factory Default Protocols
Microcurrent practitioners or medical doctors usually program the unit with
customized protocols for patients according to their therapy needs. The following
table is an example of a protocol including 10 frequency pairs. Each frequency pair
includes parameters Frequency 1 “CH1”, Frequency 2 “CH2”, Current Intensity
“I”, Time “T”, Waveform “WF”, etc. Please refer to “Waveform Description” of
this document for detailed explanation of all parameters CH1, CH2, Current
Intensity, Period, K0~K3, Polarity, and Phase of a frequency pair. The multiple
frequency pairs will run in sequence when a protocol is started.
(Note that the values in this table are to demo the concept and may not be
for actual therapy.)
To Next Page
Loading...