85-03-01060-M FV44i Décor Gen 3 Page 57
9. Locate Pilot Light on left side of firebox between the two air shutter
boxes. While holding the pilot base body with large vice grips
tightly, loosen pilot light hood using a 7/16” open end wrench on
the hex shaped base. Rotate counter clockwise ¼ turn to loosen. DO
NOT REMOVE THE PILOT HOOD, ONLY LOOSEN.
10. Pilot arrives from the factory set for NG. Push NG/LP adjustment clip
inward all the way to set it for LP. If you see “NAT” printing on the
adjustment clip, this indicates that the pilot is set to burn NG. Push
clip in so that “NAT” is not visible.
11. Tighten down hex shaped base of pilot using a 7/16” open end
wrench.
CAUTION: Always use one 7/16” open end wrench and one large
pliers or vice grips tool to hold, loosen and tighten pilot hood
base to prevent damage to pilot mount bracket.
Pinch Pilot Base with Vice Grips
Pilot Body
Pilot Orifice Selection
To Next Page
