To Next Page
A
Anthony DavisSep 9, 2025
What does 'ENGAGED' mean on the Menvier Security Control Panel when sending a test call?
- MMichael HullSep 9, 2025
The recipient is on another call. Wait until they have finished the call and try again.
What does 'ENGAGED' mean on the Menvier Security Control Panel when sending a test call?
The recipient is on another call. Wait until they have finished the call and try again.
Why won't my Menvier Security TSD402 Control Panel dial the programmed number?
Check the telephone number you are calling has been entered correctly.
Why does the Menvier Security TSD402 Control Panel beep and display 'PLEASE RE-RECORD'?
The TSD402 Menvier Security Control Panel `beeps' every 30 seconds and the display shows: PLEASE RE-RECORD because the mains and battery power for the system has been interrupted, and the speech dialler messages have been erased. Re-program all messages as required (contact your installation company for further advice if the the problem re-occurs).
What to do if the recipient can't acknowledge the Menvier Security TSD402 call by pressing [8]?
Instruct the recipient in the correct procedure (see page 19). Call the recipient and ask them to press the number [8] button on their telephone for 3 seconds. If you hear anything other than a 3 second tone, their telephone is not capable of acknowledging the TSD402. This may be overcome by using a tone pad to simulate the modern dialling tones. Contact your installation company for further details.
Why does the Menvier Security TSD402 continue to dial after the call is acknowledged?
The `Acknowledgement Option' is set to `CLEARED BY ANY 2' or `CLEARED BY ALL 3'. Check the option is set to your required setting (see page 22).
Procedure for arming the system in the 'Away' mode for complete security.
Procedure for arming the system in the 'Home' mode for partial security.
Procedure to disarm the alarm system via the entry route.
Steps to reset the system following an alarm activation.
Allows User 1 to change their personal passcode.
Accesses the menu for programming speech dialler settings.
How to record custom voice messages for alarm calls.
Common problems and solutions for the alarm system's operation.
Common problems and solutions specific to the speech dialler function.
General| Part No | TSD402 |
|---|---|
| Frequency | 50Hz |
| Input Voltage | 230V AC |
| Outputs | 2 |
| Operating Temperature | -10°C to +50°C |
