ON THE WATER
SECTION 3
Page 28 CMD-4081877 / 90-865861040 MARCH 2004
00000 was CD864 with header change
Operation Chart - 2.8 EI 200
STARTING
PROCEDURE
AFTER
STARTING
WHILE
UNDERWAY
STOPPING &
SHUT DOWN
Turn on and run engine
compartment bilge
blower, if so equipped,
for five minutes.
Observe all gauges and
warning lights to check
condition of engine. If
not normal, stop engine.
Frequently observe all
gauges and indicator
lights to monitor
engine condition.
Shift remote control
lever to neutral position.
Check for leaks - fuel,
oil, water, fluid, etc.
Check for fuel, oil,
water, fluid, and exhaust
leaks, etc.
Operate engine at idle
speed several minutes
to allow the
turbocharger and
engine to cool.
Check shift and throttle
control operation.
Prime fuel injection
system, if necessary.
Turn key switch to OFF
position.
Turn battery switch, if so
equipped, to OFF.
Turn key switch to RUN
and check that lights
and indicator lamps
come on.
Close seacock, if so
equipped.
Turn key switch to START,
after indicator lamp for the
glow plugs (if so
equipped) ceases.
Release key when the
engine starts.
Flush seawater cooling
circuit, if operating in
saltwater area.
Check that charge
indicator and oil pressure
indicator lamps cease
AFTER engine starts.
Warm-up engine at idle
rpm for several minutes.
Open seacock, if so
equipped.
Open fuel shutoff valve,
if so equipped.
Open engine hatch. Air
out bilge completely.
Turn battery switch ON,
if so equipped.
Check steering
operation.
Close fuel shutoff valve,
if so equipped.
To Next Page
Loading...
