Mercury 2.8 EI 200 - Filling

MAINTENANCE
SECTION 5
Page 62 CMD-4081877 / 90-865861040 MARCH 2004
CE463
Filling
1. If necessary, add specified automatic transmission fluid through the dipstick threaded
hole to bring the level up to the maximum mark on the dipstick.
IMPORTANT: Use only specified Automatic Transmission Fluid (ATF).
ÍÍ
ÍÍÍ
a
b
c
d
79465
a-Dipstick
b-Threaded hole
c-Maximum fluid level
d-Minimum fluid level
Model
Capacity
liters
(U.S. qts)
Fluid type Part Number
ZF Marine 63A 3 (3-1/4)
1
D III A t ti T
Obt i
ZF Marine 63IV 4 (4-1/4)
1
Dexron III Automatic Trans-
mission Fluid or Equivalent
Obtain
Locally
ZF Marine 45A 4 (4-1/4)
1
mission Fluid or Equivalent
Locally
1
Always use the dipstick to determine the exact quantity of oil or fluid required.
NOTE: If the transmission fluid level was extremely low, contact your authorized Cummins
MerCruiser Diesel dealer/distributor.
2. Install the dipstick.
IMPORTANT: To accurately check the fluid level, the engine must be run at 1500 rpm
for 2 minutes immediately prior to checking the level.
3. Refer to Checking and check the fluid level.