ON THE WATER
SECTION 3
CMD-4081877 / 90-865861040 MARCH 2004 Page 29
00000 was CD863 with changes to Engine Oil bullet point
Starting, Shifting and Stopping - 2.8 EI 200
WARNING
Do not use volatile starting aids, such as Ether, Propane, or Gasoline in the engine
air intake system. Explosion hazard resulting from ignition of vapors by glow plugs
could cause severe personal injury and engine damage.
CAUTION
It is good practice to ventilate the engine compartment prior to servicing any engine
components to remove any fuel vapors which may cause difficulty breathing or be
an irritant.
BEFORE STARTING THE ENGINE
CAUTION
Do not operate engine without water flowing thru seawater pickup pump, as pump
impeller may be damaged and subsequent overheating damage to engine or drive
unit may result.
IMPORTANT: Observe the following before starting:
• Provide water to the seawater pickup pump.
• Never operate the starter motor longer than 15 seconds at a time, to avoid
overheating the starter motor. If engine does not start, wait 1 minute to allow
the starter motor to cool; then, repeat starting procedure.
• Ensure engine crankcase is filled to correct level with the proper grade of oil
for the prevailing temperature. Refer to Specifications - Engine Oil.
• Ensure all electrical connections are secure.
• Check the air cleaner for proper installation of filter element.
1. Check all items listed in the Maintenance Schedules and Operation Chart. Refer to Table
Of Contents.
2. Perform any other necessary checks, as indicated by your dealer, or specified in your
boat owner’s manual.
To Next Page
Loading...
Need help?
General