STORAGE AND RECOMMISSIONING
SECTION 6
Page 94 CMD-4081877 / 90-865861040 MARCH 2004
CD928 w / changes
Recommissioning
NOTICE
Refer to Cold Weather, Seasonal Storage, And Extended Storage - Precautions,
BEFORE proceeding.
NOTE: Discharge of propylene glycol into the environment may be restricted by law.
Contain and dispose of propylene glycol in accordance with Federal, State, and local laws
and guidelines.
1. On engines that were prepared for Extended Storage: Refer to your Cummins
MerCruiser Diesel dealer / distributor and have the seawater pump impeller installed if
it was removed for storage.
2. On engines that were prepared for Cold Weather (Freezing Temperature),
Seasonal Storage or Extended Storage: Refer to Section 5 - Draining The Seawater
System and drain the propylene glycol into a suitable container. Dispose of the
propylene glycol in accordance with Federal, State, and local laws and guidelines.
3. Ensure that all cooling system hoses are in good condition, connected properly, and
hose clamps are tight. Verify that all drain valves and drain plugs are installed and tight.
4. Inspect all drive belts.
5. Perform all lubrication and maintenance specified for completion Annually in Section
5 - Maintenance Schedule, except items that were performed at time of engine layup.
6. Fill the fuel tanks with fresh diesel fuel. Old fuel should not be used. Check fuel lines and
connections for leaks and general condition.
7. Replace the fuel filter
CAUTION
When installing battery, connect POSITIVE (+) battery cable to POSITIVE (+) battery
terminal FIRST, and NEGATIVE (–) battery cable to NEGATIVE (–) battery terminal
LAST. If battery cables are reversed, or connection order is reversed, electrical
system damage will result.
8. Install a fully charged battery. Clean the battery cable clamps and terminals. Reconnect
the cables (see the CAUTION listed above). Secure each cable clamp when
connecting. Coat terminals with a battery terminal anti-corrosion spray to help retard
corrosion.
To Next Page
Loading...
