MAINTENANCE
SECTION 5
Page 73CMD-4081877 / 90-865861040 MARCH 2004
00000 was CD882 using subsub only from mod
Filling
NOTE: Follow this procedure after installing new filter or if fuel has been drained from filter
checking for water.
1. Loosen the bleed screw on fuel filter bracket.
a
8001580015
Typical
a-Bleed screw
b-Bleed screw
2. Move the plunger on the hand pump/primer up and down repeatedly, until an air free
stream of fuel flows from the bleed screw. Filter is full when this occurs.
a
b
74726
Typical
a-Plunger
b-Fuel from bleed screw
3. Tighten the bleed screw.
To Next Page
Loading...
