COLD WEATHER OR EXTENDED STORAGE
119
1. Ensure that all cooling system hoses are connected properly
and hose clamps are tight, all removed drain plugs have been
installed and are tight.
!
CAUTION
Disconnecting or connecting the battery cables in the incorrect
order can cause injury from electrical shock or can damage the
electrical system. Always disconnect the negative (‑) battery
cable first and connect it last.
2. Install a fully‑charged battery. Clean the battery cable clamps
and terminals and reconnect cables. Tighten each cable
clamp securely when connecting.
3. Coat battery terminal connections with an anti‑corrosion
agent.
4. Perform all checks in Operation Chart in the
Before
Starting
column.
5. Refer to Flushing Cooling System before starting engine.
6. Supply water to the engine cooling system.
ENGINE STARTING PROCEDURE
IMPORTANT: The throttle should not be advanced until the engine
idles and runs smoothly and the water temperature reaches a
minimum of 54 °C (130 °F). Advancing the throttle prematurely
while the PCM is in its rich running mode will result in poor engine
starting and performance.
1. Connect the main permanent fuel line to the engine.
2. Do not advance the throttle until the engine idles and runs
smoothly and the water temperature reaches a minimum of 54
°C (130 °F).
3. Start the engine. If the engine does not start right away, crank
the engine over for a maximum of 10 seconds at a time and
stop.
4. Repeat the cranking procedure until the engine starts and runs
smoothly. Observe the instrumentation to ensure all systems
are functioning.
5. Inspect engine for fuel, oil, fluid, water and exhaust leaks.
6. Check the steering system.
To Next Page
Loading...
Need help?
General
