MAINTENANCE
61
Interval Task
Every 50 hours of operation.
Perform 25 Hour Maintenance Items.
Drive Mounting Nuts ‑ Tighten to
136 Nm (100 lb. ft.)
Steering System ‑ Inspect for loose,
damaged or missing parts. Lubricate
the steering cylinder pivot points.
Every 100 hours of operation or
annually, whichever occurs first
Peform 25 and 50 Hour Maintenance
Items.
Drive Unit Bellows and Clamps ‑
Inspect.
Sterndrive Unit Input Splines (Internal
and External) ‑ Lubricate with Optimol
Paste White T Grease.
Drive Input Shaft U‑joints ‑ Lubricate.
Drive ‑ Change Oil
1.
Transom Input Shaft Bearing Housing
‑ Change the oil.
1.
Every 200 hours of operation or once a
year, whichever occurs first.
Peform 25, 50, and 100 Hour
Maintenance Items.
Engine Alignment ‑ Check.
Propeller Shaft Bearing ‑ Inspect by
measuring shaft deflection.
Every 200 hours of operation
1.
Drive ‑ Change oil and filter
Every rebuild Drive ‑ Change oil and filter
Checking Fluid Levels
CHECKING CRANKCASE OIL
IMPORTANT: Check the engine crankcase oil at the intervals
specified in the Maintenance Chart.
NOTE: Oil consumption is greatly dependant on engine speed.
Consumption is highest at wide‑open‑throttle and decreases
substantially as engine speed is reduced. It is common for big
block, high‑performance engines to use up to one quart of oil in
one to five hours, if the engine is operated continuously at the
upper end of the RPM range.
1. Severe duty requires more frequent service
To Next Page
Loading...
Need help?
General
