MAINTENANCE
101
INSPECTING BELTS
NOTE: Minor, transverse cracks (across the belt width) may be
acceptable. Longitudinal cracks (in the direction of belt length) that
join transverse cracks are not acceptable.
a - Fraying
b - Transverse cracks
c - Longitudinal cracks
The belt will have to be replaced for the following conditions:
• Excessive wear
• Cracks as explained previously
• Fraying
• Glazed surfaces
Fuel Filters
WATER SEPARATING FUEL FILTER
!
WARNING
Fuel is flammable and explosive. Ensure the key switch is off and
the lanyard is positioned so that the engine cannot start. Do not
smoke or allow sources of spark or open flame in the area while
servicing. Keep the work area well ventilated and avoid
prolonged exposure to vapors. Always check for leaks before
attempting to start the engine and wipe up any spilled fuel
immediately.
To Next Page
Loading...
