EasyManuals Logo

Mercury HP700 SCi User Manual

Mercury HP700 SCi
138 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
MAINTENANCE
60
Interval Task
Every 200 hours of operation or once
a year, whichever occurs first.
Peform 25, 50, and 100 Hour
Maintenance Items.
Engine Alignment ‑ Check.
Propeller Shaft Bearing ‑ Inspect by
measuring shaft deflection.
Every rebuild
Lower Gear Housing ‑ Oil and filter
change
NXT¹/SSM DRIVE MAINTENANCE SCHEDULE
NOTE: The following maintenance charts should be used as a
guideline. Depending on the type of boat, optional equipment, the
application and/or conditions of use, it may be required that the
maintenance intervals be modified. Work closely with your
authorized Mercury Marine dealer to develop a specific
maintenance schedule designed for your application.
Interval
Task
Check prior to use and every 3 hours of
operation.
Drive, Transom, and Propeller ‑
Inspect.
Lower Gear Housing Oil ‑ Check level.
Power Trim Pump Oil Check level and
for any water contamination. Replace if
necessary.
Anodes ‑ Inspect for erosion.
Initial break‑in at 25 hours. Drive ‑ Change Oil and filter
Every 25 hours of operation or every 90
days, whichever occurs first.
Tie‑bar Mounting Bracket Nuts ‑
Inspect and tighten to specifications as
needed.
Propeller Shaft ‑ Lubricate.
Propeller Nut ‑ Retighten.
Anodes ‑ Inspect for erosion.
Sterndrive ‑ Inspect, clean, and spray
with rust preventative.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury HP700 SCi and is the answer not in the manual?

Mercury HP700 SCi Specifications

General IconGeneral
BrandMercury
ModelHP700 SCi
CategoryOutboard Motor
LanguageEnglish

Related product manuals