3. Locate the engine flush port on the boat transom and insert the
quick‑connect fitting.
a - Flush quick connector
b - Engine flush port on transom
4. Turn on the water tap.
5. Press the start button on the boat‑mounted automatic outboard flushing
system, or the remote‑mounted button if equipped. See the user's manual
that comes with the unit for more details.
a - Start button on automatic outboard flushing system
b - Remote‑mounted start button (if equipped)
6. Once the system has completed the flushing procedure, turn off the water
tap and remove the water hose.
Top Cowl Removal and Installation
NOTE:It is recommended to remove and install the cowl while standing inside
the boat.
REMOVAL
1. Tilt the outboard up so the top of the cowl is facing you.
72594
WATER INLET
OUTBOARD FLUSHING SYSTEM
START
MAINTENANCE
eng 91
To Next Page
Loading...
