Mercury Racing 500R - Checking Power Steering Fluid

4. Remove the power trim fill cap. The fill cap only requires 1/4 turn to
remove.
a - Tilt support lever
b - Power trim fill cap
c - Tilt support bracket
d - Pedestal
5. The fluid level should be approximately 25 mm (1 in.) from the top of the
fill neck. Add Quicksilver or Mercury Precision Lubricants Power Trim and
Steering Fluid. If not available, use automotive automatic transmission
fluid (ATF).
Description Where Used Part No.
Power Trim and
Steering Fluid
Power trim system 92-858074K01
6. Install the power trim fill cap. Tighten fill cap 1/4 turn. Cap will snap in
place. Do not tighten beyond this point.
Checking Power Steering Fluid
!
WARNING
Dirt or contaminants in the hydraulic steering system can damage the
steering system's internal components. Damaged components can lead to
serious injury or death due to loss of boat control. Do not allow dirt or
contamination to enter the helm, lines, or cylinder of this steering system
and perform all hydraulic inspections, service, or assembly procedures in a
clean work area.
a
c
d
b
29312
MAINTENANCE
 116 eng