Mercury Racing 500R - Checking Power Trim Fluid

FUEL SUPPLY MODULE (FSM) STRAINER
1. Remove the M6 x 20 screw securing the strainer fitting to the exhaust
tube.
a - Starboard lower cowl
support bracket
b - Starboard idle relief
muffler
c - Strainer fitting
d - M6 x 20 screw
2. Remove any debris from the strainer fitting.
3. Install the strainer fitting into the exhaust tube.
IMPORTANT:Ensure that the O‑ring is in place on the strainer fitting.
4. Apply Loctite 272 to the M6 x 20 screw threads.
5. Install the strainer into the exhaust tube.
6. Tighten the screw to the specified torque.
Description
Nm lb‑in. lb‑ft
M6 x 20 screw 10 88.5 –
Checking Power Trim Fluid
1. Tilt outboard to the full up position.
2. Rotate the tilt support bracket down.
3. Lower outboard until tilt support bracket rests on pedestal.
a
b
c
d
76817
MAINTENANCE
eng 115 