IMPORTANT:Repeated removal and insertion of the dipstick will
subsequently deposit oil further up the dipstick tube which could cause an
error reading the oil level.
a - Safe operating range
b - General area after an oil change
c - Add 1.8 Liter (2 US qt) of oil
6. If none of the beads show the oil level, remove the oil filler cap and add
1.8 Liter (2 US qt) of the specified outboard motor oil.
Description Where Used Part No.
Mercury Racing 10W-30
MRX Full Synthetic Oil
500R crankcase 8M0169264
7. Allow a few minutes for the oil to drain into the sump and insert the oil
dipstick.
8. Remove the dipstick and inspect whether the oil level is within the safe
operating range.
9. Install the dipstick and oil filler cap hand‑tight.
10. Close the service access door and lock it into place by pushing on the
port side of the door.
Adaptive Speed Control Propping with CDS G3
A special propping procedure using CDS G3 should be used for optimum
propping.
1. Install the best guess propeller.
2. Connect CDS G3 to the engine, and monitor the following values:
•
RPM ‑ engine speed. In this example, for a new boat with a new
engine, the ideal RPM is at the upper end of the RPM range.
•
DemandLinear ‑ requested handle position. This should be at 100%
at wide‑open throttle. If this value is not at 100% when the handle
is in the full forward position, DTS helm configuration needs to be
performed.
•
DemandLinear_with_Guardian ‑ software controlled limit with any
engine protection/Guardian limits applied. This value should also be at
100% when underway and with the handle in the full forward position.
If this value is less than the DemandLinear value, check faults for
Guardian cause and correct the issue.
MAINTENANCE
eng 125
To Next Page
Loading...
