Mercury Racing 500R - Propeller Replacement-38.1 MM (1.5 In.) Diameter Propeller Shaft

Each anode requires periodic inspection, especially in saltwater, which will
accelerate the corrosion. To maintain corrosion protection, always replace
the anode before it is completely corroded. Never paint or apply a protective
coating on the anode, as this will reduce the effectiveness of the anode.
a - Bottom of transom bracket
(1)
b - Bottom of each power trim
ram (2)
c - Bottom of power trim
pedestal (1)
d - Underside of anti‑ventilation
plate (1)
Propeller Replacement—38.1 mm (1.5 in.) Diameter Propeller
Shaft
!
WARNING
Rotating propellers can cause serious injury or death. Never operate the boat
out of the water with a propeller installed. Before installing or removing a
propeller, place the drive unit in neutral and activate the lanyard stop switch
to prevent the engine from starting. Place a block of wood between the
propeller blade and the anti‑ventilation plate.
PROPELLER REMOVAL
1. Shift the outboard into the neutral position and activate the lanyard stop
switch.
74980
d
a
b
c
MAINTENANCE
eng 101 